LASER de COUPE 20W 12V NEJE
NEJE 20W 12V TTL / PWM Cutting Laser Tube Module for MASTER Engraver
Main applications: cutting, metal engraving, drawing depth engraving, etc. (Especially good at cutting, It can cut wood (3-7mm).
It supports metal engraving including alumina oxide, copper and other non-reflective materials, depth of engraving ( 0.5-3mm wood), thickness of cutting(2mm)
Supported engraving materials: Wood, gray paper, leather, bamboo, blackening plastics, rubber, alumina oxide, copper, etc.
It is not possible to directly engrave the metal with strong mirror reflectivity, which may cause injury to the operator or burn the laser.
Interface specification: 4pin PH2.0 (red: 12V, black: GND, yellow: PWM, green: temperature signal)
Wavelength: 450nm
Radiator size: 30x80mm
Material: copper + aluminum
Drive position: built-in
Is the power adjustable: PWM can be adjusted
Drive protection: surge protection, overvoltage protection
Input power: approx. 12V 2A (without fan power)
Line length: 300mm
Control line installation method: pluggable
Fan size: 30x10mm
Fan speed: 15000 rpm
Controllable temperature: less than 60 degrees Celsius
Focus range: 5-50mm
Best focal length: 10mm from the light exit
Safety Warning: Please apply this module under the premise of safety protection!
Recommended application machine: NEJE Master
Note: NEJE Master comes standard with 12V 2A charger. If you want to upgrade your
Old machine, you need to prepare another 12V 3A power supply.
